Diablo DSP-55 Plug-in Vehicle Loop Detector 10 Pin for All-O-Matic Elite Linear
Diablo DSP-55 Plug-in Vehicle Loop Detector 10 Pin for All-O-Matic Elite Linear Plug-in loop detector for the following operators All-O-MaticElite AccessLinear ProMaximum ControlsViking AccessAdjustable frequency and Sensitivity Features Can be connected to a standard inductive loop as well as Diablo Controls mini-loops.Small profile, perfect for many installations.Three Solid State outputs.Fail-safe or Fail-secure operation.Wide low-voltage operation Separate Power/Fail and Detect LEDs.B Outputs can be presence, pulse on entry, pulse on exit, or loop fail.Flicker display shows occupancy of the detection zone when operating in a pulse mode.Delay or extension time is possible.
Diablo Controls DSP- 55 Plug-in Vehicle Loop Detector
Diablo Controls DSP- 55 Plug-in Vehicle Loop Detector Diablo Controls DSP- 55 Plug-in Vehicle Loop Detector The DSP-55 detector is intended to be a full-featured single channel detector that can work with both inductive loops as well as the new Diablo Controls mini-loops. Many features have been included which are normally found only on more expensive models. The small package is powered by a high-performance 8-bit microcontroller that does not skimp on performance. The DSP-55 detector has a small footprint and was designed to retrofit into many existing locations that may require a detector upgrade. This allows maintenance personnel to carry only one detector to meet most, if not all, of their vehicle detection needs.The detector uses a 10-pin Molex connector for its connections and has three solid-state (open-collector) outputs. The solid-state outputs allow for a smaller total package size, lower power consumption, and elimination of contact bounce.FeaturesCan be connected to a standard inductive loop as well as Diablo Controls mini-loops.Small profile, perfect for many installations.Three Solid State outputs.Fail-safe or Fail-secure operation.Wide low-voltage operation Separate Power/Fail and Detect LEDs.B Outputs can be presence, pulse on entry, pulse on exit, or loop fail.Flicker display shows occupancy of the detection zone when operating in a pulse mode.Delay or extension time is possible. Payments & Returns Policy