Ultra Custom Pools

Item Tag: Multi

Aprilaire 8448 Non-Programmable Multi-Stage Electronic Thermostat

Aprilaire 8448 is a non-programmable, multi-stage electronic thermostat. Controls 2 heat/ 2 cool conventional or 4 heat/ 2 cool heat pump. It features a large, backlit LCD screen and soft touch keys. The display simultaneously shows room temperature, current setpoint, and outdoor temperature. Notifies you when it’s time to change the air filter, humidifier pad, or request routine HVAC service. Runs the fan for 10 minutes every half hour to improve indoor air quality and eliminate hot/cold spots. Dual powered by hardwire or batteries

Mortise Lock Active Multi-Point Lock Body Fits Marvin Ultimate Inswing Doors

We are an Authorized Distributor for Andersen, Larson, Marvin, Pella, GU Ferco, Hoppe, Emtek, Roto, Milgard, Peachtree, Weathershield, and many more. Shop our store for your door and window hardware needs. Customer Service Hours Monday-Friday 8am-4pm CST Marvin Ultimate Inswing doors manufactured 1/17/2000 to present.Active Multi-Point lock body, used with Concealed Rods that screw into top and bottom.DOES NOT include rods, lock case only. American 5 pin cylinderHandle Spacing: 3-5/8 inch (92mm)Backset: 2-3/8 inch (60mm) with faceplate (measures 2-5/16 as shown)Tapered Deadbolt throw 1 inch (25.4mm)Markings: Patent NO. 6,209,931Marvin Part Number 05700130Marvin Related Parts:40160 – Single point lock, no rods395040 – Face plate for single point lockHow to Operate Lock:1. Lift handle to Extend vertical shootbolt rods2. Turn Key or Thumbturn to extend deadbolt and secure rods in locked position3. Reverse process to unlock door.Change Handing:1. Insert screw driver into slot behind latch2. Pull down on handing release, latch pops out3. Rotate latch and push back into lock caseAlways check function of lock before closing doorRemoval / Installation Note:Removal:1. Remove door from hinges and lay on edge2. Remove Top and Bottom plastic guides, held in place with Philip head screw3. Remove rods from top and bottom of door, Unscrew, counter clockwise4. Remove handle set and faceplate5. After removing faceplate from door edge, remove screws holding lockInstallation:1. Install lock body in door2. Re-install Lock faceplate and handle set.3. Test lock after you install in door and before putting the plastic guides in place.4. If working properly, install plastic guides and try again, Shootbolts should extend 3/4″ – 1″5. Install door back in frame and test lock again before closing door.NOTE:You can disconnect the top rod and most of the time pull the bottom rod out with the gearbox.However, to get it back in the door, the plastic guide in the bottom is a problem, and you will most likely have to remove the guide to get the rod back in the door.