Set of 3/4 Top / Bottom FRP Distributors for FLECK Water Softener 1.05″ Strainer
1. Top distributor 3/4″ F0601, 0.25mm slots Prevents resin loss during backwash. The Fleck 18280 is an upper media screen (aka Top Collector) for the Fleck 5600 and 2510 product platforms. It counter-clockwise twist-locks to the bottom of the control valve and receives a standard 1.05″ OD riser tube. Known analogues:Top 1.05 Twist On Basket Strainer 1.05 O.D. DistributorFLECK UPPER MEDIA SCREEN (18280)FL18280-01 Top Collector, Bayonet, 1.05″ X .020 (White)Fleck FL18280 COLLECTOR, TOP, 1″ X .011. (Grey) Twist-on style. Used for most Fleck Residential Valves, as well as Legacy and Runxin Residential Valves.TDB1050-FMBS, Fleck 5600 Top Bskt, 1.050 FM, 18280-02Supplier Part #: 18280-02 Fleck 5600 Top Bskt, 1.050 FM Fleck 5600 Top Basket, 1.050″ Fine MeshBoth Top/Bottom Distributor are high-efficiency Filtration Water Softeners Parts. 2. Bottom distributor 3/4″ F0602, 0.25mm slotsPrevents resin loss during Service. The F0602 is an lower media screen (aka Bottom Collector) for any 1.05″ (3/4″) product platforms. It fits a standard 1.05″ OD riser tube, glue-locks to the bottom side of the dip-pipe.Lower distributor 3/4″ F0602, 0.25mm slots1.05 inch O.D. Bottom Distributor .010″ – .013″ slotsUsed to make Distributor Tube with a piece of 3/4″ SDR21 PVC Pipe ( gluing the distributor to the PVC pipe with PVC Cement ).This 1.05″ O.D. pipe size is used on all new residential valves.Some older valves used the 13/16″ O.D. tubes, but you can still use the larger 1.05″ distributor and adapt to your old valve by gluing ( use PVC Cement ) a 6″ section of your old 13/16″ tube into the center of a piece of 3/4″ PVC pipe that is Schedule 40.You don’t use a “coupler”, but the actual pipe, 3/4″ Schedule 40 PVC used with the MD1236, since the INNER diameter matches the OUTER diameter of the 13/16″ pipe it will fit tightly inside the new 3/4″ PVC ( must be Schedule 40 ). Your old distributor pipe can usually be a guide to the length or height your new pipe will need to be ( And it must be Touching the Bottom of the Tank ).If the Valve is a Fleck 5600, then you will need the new tube to be equal to the top of the resin tank ( not more than 1/4″ above ).It is helpful to “round” or “smooth” the top edges of the new PVC pipe with sand paper so that insertion into the valve does not damage the distributor o-ring in the valve body. Both Top/Bottom Distributor are high-efficiency Filtration Water Softeners Parts.
Set: Cone Bottom Top Distributor Basket Strainer for Water Softener ✅+Riser tube
When variations with the riser tube chosen, the length of the riser tube (with the basket) is The QUTO Cone Top-Bottom Distributor Basket Strainer Screen set includes heavy-duty PVC strainers for water softeners.