3/8″ – 1″ Valve Coil 12 VDC 24V DC/AC 110/120 Volts AC – FOR USE WITH OUR VALVES
VAC 22VA | VDC 18 Watts. 12V DC, 24V DC/AC, or 110/120 VAC. Fast Acting (Less than one second). (These will not work with other manufacturers valves). Fits Brass Valve Sizes 3/8″ to 1″.
1/4″ Plastic Push In Quick Connect Solenoid Valve 12 Volts DC or 120V AC
12 Volts DC or 120 Volts AC. Push Connect Valve works with 1/4″ OD Tubing. Pressure Limits. 25 to 175° F | -5 to 80°C. Low Viscosity Fluids (below 20 cst). Fast Acting (Less than one second). Seal Material.
1/4″ Electric Solenoid Valve Brass 12V DC 24V 110/120 Volts AC Water Air Gas
Untitled Document Normally Closed – opens when power is applied Choose Your Own Voltage Function Normally Closed Connection 1/4” Inch FNPT Temperature Range 15 – 250F Pressure Range 0 – 115 PSI Power Requirements 10 Watts *Suitable Media Water – Air – Fuel Specifications Body Material Brass Components Stainless Steel Seal Material Viton® Diaphragm Operation Type Direct Acting Valve Coil Connection Lead Wires Orifice Size 3 mm Cv Value 0.40 *Duty Cycle 100% but not indefinitely Weight 10 oz Height 2.62″ Length 1.60″ port to port Width 1.20″ Connection – No Polarity, + and – can be interchanged. The valve timing is uncertain, however it is very fast acting. Less than one second. *The Orifice size is 3mm and Cv value is 0.4. This valve is not recommended for gravity fed systems because of the small orifice size Mounting position is preferably coil up but can be mounted in any position. *Consult a chemical compatibility expert for correct seal and valve body material choice. *Duty Cycle – Like most solenoid valves the coil will become hot to the touch when left on continuously. The temperature will stabilize without failure. Leaving the valve powered on for long periods of time will reduce the life of the coil. Whenever possible the valve should be installed in a well ventilated are to increase the life of the coil. The valve is not intended to be left energized as a fail-safe for power outages. In this case please contact us for other options. A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly. Listing and template services provided by inkFrog
1-1/4″ – 2″ Valve Coil 12 VDC 24V DC/AC 110 Volts AC – FOR USE WITH OUR VALVES
VAC 40VA | VDC 30 Watts. 12V DC, 24V DC/AC, or 110/120 VAC. Fast Acting (Less than one second). (These will not work with other manufacturers valves). Fits Brass/SS Valve Sizes 1-1/4″ to 2″.